Nokia C3-01 Touchscreen Problem Full Ways Jumper

Nokia C3-01 Touch Solution
Nokia C3-01 Touchscreen Connecter Ways,
Jumper, Track, Path
Nokia C3-01 Touch Not Working Repair

If you are looking and having trouble finding
where to put a jumper if the touchscreen pin
connector is already gone or lifted due to water
water damaged on Nokia C3-01.
This solution
might help you to ease out your hard time
finding where to solder a jumper wire on it just
to fix a touchscreen not working problem.

This solution exactly shows the connection line
paths of the touchscreen pin connector of the
Nokia C3-01 PCB board layout. You may only
need to check its corresponding pinouts if the
connection were already cut-off or have an open
circuit, then solder a jumper on it, for it is only
the options.
Nokia C3-01 Touchscreen Pin Connector Jumper
Solution

Jut also check out all the corresponding
components where the particular pins is
connected for it will also cause the problem if
already damaged or corroded. The two coils are
for the touchscreen supply voltages 1.8V and
2.8V , the corresponding resistors are for the
touch screen data signal filters which has a
rated value of 100ohms each. So, that's it and
hope this helps to you on fixing Nokia C3-01
touchscreen problem.

GAURAV MOBILE

7:54 PM